OEM design validation
2306 2550KV BLDC Motor
Validating this motor in Little Rock. Specifications are published as each measurement is finished.
This is the motor Manoa Systems is validating on OEM hardware, for multirotor configurations and robotics prototypes.

- 2306Stator size
- 2550KV
- 4SRecommended cells
- 5 inProp size
- 36 gWeight (with wires)
- 16x16 mmMount pattern
Specifications
6 of 27 specifications published.
| Physical | |
|---|---|
| Stator size | 2306 |
| Weight (with wires) | 36 g |
| Mount pattern | 16x16 mm |
| Electrical | |
| KV | 2550 KV |
| Recommended cells | 4S |
| Performance | |
| Prop size | 5 in |
In testing
- Testing Configuration
- Testing Mount screw
- Testing Stator diameter
- Testing Stator height
- Testing Shaft diameter
- Testing Shaft length
- Testing Motor diameter
- Testing Motor height
- Testing Internal resistance
- Testing Idle current
- Testing Max continuous current
- Testing Peak current
- Testing Max power
- Testing Max thrust
- Testing Voltage range
- Testing Bearing type
- Testing Magnet grade
- Testing Wire gauge
- Testing Lead length
- Testing Bell material
- Testing Operating temperature
Included hardware
- 4× short mounting screws (for standard or thin mounting plates)
- 4× long mounting screws (for thick carbon fiber arms or reinforced brackets)
- 8 screws total per motor
Questions
When will the rest of the specs be published?
As each measurement is finished. A specification moves into the table when the value is known.
Where is this motor made?
This motor is OEM hardware, used to validate the design. Manufacturing moves to the United States and allied nations, with assembly in the United States, and then to complete manufacturing in the United States.